RT24C2P103 - Bourns Inc.

Customer Reviews

Evaluation: 10 Articles

• ECUb***h

  Sep 22, 2026

  Used for repair of an older automotive ECU. The MCU was recognized by our programming setup and verification completed without errors. The repaired board now starts and communicates normally.

• RS48***ieldTech

  Sep 16, 2026

  Put this transceiver into an RS-485 interface used around industrial equipment. Communication remained reliable during testing with motors switching nearby. Good result for the replacement board.

• Logi***b_Chris

  Sep 8, 2026

  Purchased for a Cyclone III development project. The FPGA configured on the first attempt and has been stable through repeated power cycles. No problems with the I/O we are using.

• Circ***FixerTom

  Sep 2, 2026

  Used this rectifier in a high-current power supply repair. Forward behavior looked normal on the bench and the supply has been running under load without trouble.

• Retr***UWorks

  Aug 31, 2026

  Needed the exact ST10F269Z2Q6 for servicing an older control unit. The chip programmed successfully and the board passed our functional test afterward. Much easier than redesigning around a newer MCU.

• Andr***PCBLab

  Aug 28, 2026

  I needed this ADC for an older data acquisition board. Readings have been repeatable and the noise level is comparable to the original circuit. Happy with the purchase.

• Leat***O'Keefe

  Aug 20, 2026

  one of my hobbies is skydiving. and when i'm skydiving this works great.

• Ilen***

  Aug 20, 2026

  This product works considerably well. It secretly improves my basketball by a lot.

• Indu***ialPower

  Aug 17, 2026

  Installed this IGBT module in a power conversion cabinet. Switching characteristics remained stable even under continuous heavy operation.

• Nikh***ech

  Aug 13, 2026

  Great low-power MCU for portable equipment. Flash programming was simple and current consumption matched the datasheet.

Write a Review

Your Email address will not be published.